README.txt
169 lines
| 6.3 KiB
| text/plain
|
TextLexer
pellion
|
r639 | |||
This leon3 design is tailored to the Digilent Spartan3-1600E Evaluation board: | ||||
http://www.digilentinc.com/Products/Detail.cfm?Prod=S3E1600&Nav1=Products&Nav2=Programmable | ||||
Design specifics: | ||||
* System reset is mapped to SW_SOUTH (reset) | ||||
* DSU break is mapped to SW_EAST | ||||
* LED 0/1 indicates console UART RX and TX activity. | ||||
* LED 2/3 indicates DSU UART RX and TX activity. | ||||
* LED 4 indicates processor in debug mode | ||||
* LED 7 indicates processor in error mode | ||||
* The GRETH core is enabled and runs without problems at 100 Mbit. | ||||
Ethernet debug link is enabled, default IP is 192.168.0.51. | ||||
* 16-bit flash prom can be read at address 0. It can be programmed | ||||
with GRMON version 1.1.16 or later. | ||||
* DDR is mapped at address 0x40000000 (64 Mbyte) and is clocked | ||||
at 100 MHz. The processor and AMBA system runs on a different | ||||
clock, and can typically reach 40 MHz. The processor clock | ||||
is generated from the 50 MHz clock oscillator, scaled with the | ||||
DCM factors (4/5) in xconfig. | ||||
* The APBPS2 PS/2 core is attached to the PS/2 connector | ||||
* The SVGA frame buffer runs fine with 800x600 resolution. Due to the | ||||
limited number of clock buffers, no other resoltion is supported. | ||||
Note that the board does not have a video DAC, so only the MSB bit (7) | ||||
of the three colour channels is connected to the VGA connector. | ||||
A test patter can be generated using grmon-1.1.18 or later with: | ||||
draw test_screen 800 16 | ||||
* The DSU uart is connected to the female RS232 connected. | ||||
The application UART1 is connected to the male RS232 connector. | ||||
* The JTAG DSU interface is enabled. | ||||
* Output from GRMON info sys is: | ||||
ethernet startup. | ||||
GRLIB build version: 4090 | ||||
initialising .............. | ||||
detected frequency: 40 MHz | ||||
Component Vendor | ||||
LEON3 SPARC V8 Processor Gaisler Research | ||||
AHB Debug UART Gaisler Research | ||||
AHB Debug JTAG TAP Gaisler Research | ||||
SVGA Controller Gaisler Research | ||||
GR Ethernet MAC Gaisler Research | ||||
AHB/APB Bridge Gaisler Research | ||||
LEON3 Debug Support Unit Gaisler Research | ||||
DDR266 Controller Gaisler Research | ||||
LEON2 Memory Controller European Space Agency | ||||
Generic APB UART Gaisler Research | ||||
Multi-processor Interrupt Ctrl Gaisler Research | ||||
Modular Timer Unit Gaisler Research | ||||
PS/2 interface Gaisler Research | ||||
General purpose I/O port Gaisler Research | ||||
Use command 'info sys' to print a detailed report of attached cores | ||||
grlib> inf sys | ||||
00.01:003 Gaisler Research LEON3 SPARC V8 Processor (ver 0x0) | ||||
ahb master 0 | ||||
01.01:007 Gaisler Research AHB Debug UART (ver 0x0) | ||||
ahb master 1 | ||||
apb: 80000700 - 80000800 | ||||
baud rate 115200, ahb frequency 40.00 | ||||
02.01:01c Gaisler Research AHB Debug JTAG TAP (ver 0x0) | ||||
ahb master 2 | ||||
03.01:063 Gaisler Research SVGA Controller (ver 0x0) | ||||
ahb master 3 | ||||
apb: 80000600 - 80000700 | ||||
clk0: 40.00 MHz | ||||
04.01:01d Gaisler Research GR Ethernet MAC (ver 0x0) | ||||
ahb master 4, irq 12 | ||||
apb: 80000f00 - 80001000 | ||||
edcl ip 192.168.0.51, buffer 2 kbyte | ||||
01.01:006 Gaisler Research AHB/APB Bridge (ver 0x0) | ||||
ahb: 80000000 - 80100000 | ||||
02.01:004 Gaisler Research LEON3 Debug Support Unit (ver 0x1) | ||||
ahb: 90000000 - a0000000 | ||||
AHB trace 256 lines, 32-bit bus, stack pointer 0x43fffff0 | ||||
CPU#0 win 8, hwbp 2, itrace 256, V8 mul/div, srmmu, lddel 1, GRFPU-lite | ||||
icache 2 * 4 kbyte, 32 byte/line rnd | ||||
dcache 2 * 4 kbyte, 16 byte/line rnd | ||||
04.01:025 Gaisler Research DDR266 Controller (ver 0x0) | ||||
ahb: 40000000 - 50000000 | ||||
ahb: fff00100 - fff00200 | ||||
16-bit DDR : 1 * 64 Mbyte @ 0x40000000 | ||||
100 MHz, col 10, ref 7.8 us, trfc 80 ns | ||||
05.04:00f European Space Agency LEON2 Memory Controller (ver 0x1) | ||||
ahb: 00000000 - 20000000 | ||||
ahb: 20000000 - 40000000 | ||||
ahb: 60000000 - 70000000 | ||||
apb: 80000000 - 80000100 | ||||
16-bit prom @ 0x00000000 | ||||
01.01:00c Gaisler Research Generic APB UART (ver 0x1) | ||||
irq 2 | ||||
apb: 80000100 - 80000200 | ||||
baud rate 38461, DSU mode (FIFO debug) | ||||
02.01:00d Gaisler Research Multi-processor Interrupt Ctrl (ver 0x3) | ||||
apb: 80000200 - 80000300 | ||||
03.01:011 Gaisler Research Modular Timer Unit (ver 0x0) | ||||
irq 8 | ||||
apb: 80000300 - 80000400 | ||||
8-bit scaler, 2 * 32-bit timers, divisor 40 | ||||
05.01:060 Gaisler Research PS/2 interface (ver 0x2) | ||||
irq 5 | ||||
apb: 80000500 - 80000600 | ||||
0b.01:01a Gaisler Research General purpose I/O port (ver 0x0) | ||||
apb: 80000b00 - 80000c00 | ||||
grlib> | ||||
grlib> flas | ||||
Intel-style 16-bit flash on D[31:16] | ||||
Manuf. Intel | ||||
Device MT28F128J3 ) | ||||
Device ID 0418ffff008844d1 | ||||
User ID ffffffffffffffff | ||||
1 x 16 Mbyte = 16 Mbyte total @ 0x00000000 | ||||
CFI info | ||||
flash family : 1 | ||||
flash size : 128 Mbit | ||||
erase regions : 1 | ||||
erase blocks : 128 | ||||
write buffer : 32 bytes | ||||
region 0 : 128 blocks of 128 Kbytes | ||||
grlib> | ||||
grlib> lo ~/examples/dhry412 | ||||
section: .text at 0x40000000, size 53296 bytes | ||||
section: .data at 0x4000d030, size 2764 bytes | ||||
total size: 56060 bytes (63.3 Mbit/s) | ||||
read 262 symbols | ||||
entry point: 0x40000000 | ||||
grlib> run | ||||
Execution starts, 1000000 runs through Dhrystone | ||||
Total execution time: 10.5 s | ||||
Microseconds for one run through Dhrystone: 10.5 | ||||
Dhrystones per Second: 95073.0 | ||||
Dhrystones MIPS : 54.1 | ||||
Program exited normally. | ||||
grlib> | ||||